View Issue Details
|ID||Category||Date Submitted||Last Update|
|0005002||bugs||2012-07-10 11:24||2012-07-10 16:02|
|Fixed in Version|
|Summary||0005002: Trim automation changes level relations (Linear)|
|Description||if you have an automation lin of 0.0 db, And in it a step of 0-X db, and you will drag it down, the range between the lin and the step will get bigger then the original X.|
|Tags||No tags attached.|
Screen Recording 46.mov (3,000,348 bytes)
||i don't understand what the issue is here.|
Let's say I have an area where the level is 0.0 db with a small step down in the middle of -3 db.
Then I range select the area and trim it down a bit.
I would expect that the 3 db difference will not change.
In Ardour it will grow.
||See attached movie.|
Screen Recording 49.mov (2,578,556 bytes)
ok. this happens because the mapping between the GUI and actual gain coefficients being non-linear. 2 pixels at the bottom of a fader automation track is a different number of dB than 2 pixels 3/4 of the way up.
its a bit of a problem to fix because when moving individual points this difference is very desirable, so that moving control points has the same non-linear feel as moving the fader itself.
i'll give it some thought.
|2012-07-10 11:24||BenSpector||New Issue|
|2012-07-10 11:24||BenSpector||File Added: Screen Recording 46.mov|
|2012-07-10 13:01||paul||Note Added: 0013833|
|2012-07-10 13:52||BenSpector||Note Added: 0013834|
|2012-07-10 14:09||BenSpector||Note Added: 0013835|
|2012-07-10 14:10||BenSpector||File Added: Screen Recording 49.mov|
|2012-07-10 14:17||paul||Note Added: 0013836|
|2012-07-10 16:02||paul||cost||=> 0.00|
|2012-07-10 16:02||paul||Target Version||=> 3.X|